For record keeping purporses, and also as a reference post if god forbid the sensor comes crashing down one day. This is how I mount my Kinect sensor.
The sensor is mounted on the top of your typical flat screen TV. I was going to make a stand using instructions provided here, when I encountered 2 problems.
The first was that the top grills behind my TV ran the full length of the TV, so there’s no center spine area to put the tape on. Therefore I resorted to the use of a smaller tube.
I’m guessing some Asian parents should be familiar with this nutmeg oil can, it’s diameter was just the right size to angle the platform. Speaking of which, the 2nd problem was the platform.
Surprisingly I couldn’t find a simple no entry sign, or anything like that in the ACE Hardware I went to. I saw lots of STICKERS, but no signs. I ended up with a cutting mat that has a melting point of 70 degrees Celsius.
I used industrial strength velcro for all removable points, then I used some duct tape as an anchor to help ease the force of the platform pushing against the can hopefully making for a more permanent bond.
Redundancy wise, in a case of failure. I hope that my used of multiple strips of velcro on the front of the TV combined with the duct tape, will ensure that there’s no SPONTANEOUS LOSS of adhesiveness, should the heat of the TV melt the velcro strip connected to the can I should be able to see it tilt gradually and perform any repairs instead of just watching it crash to the ground.
For spatial reference
The space from the TV, to where the white couch is, happens to be JUST THE RIGHT SIZE for 2 players. 1 player is where WZ is sitting.
Powered by: newtelligence dasBlog 2.1.8102.813
The opinions expressed herein are my own personal opinions and do not represent
my employer's view in any way.
© Copyright 2017, Marauderz